Bending semiconductors generates electricity
Researchers at the ICN2 report in an article in Nature that flexoelectric-like effects are more ubiquitous than previously thought. The ICN2 researchers report that semiconductors, which can be thought of as half-way between electrical insulators and actual metals, also generate electricity in response to bending.
![Bending semiconductors generates electricity](/Imatge/663/187/FlexoelectricitatICNg,1.jpg)
This is important because semiconductors are a common family of materials that is already widely used in such important devices as transistors (the heart of integrated circuits) or photo-voltaic cells. The new results show that, from now on, it is in principle possible to use them also as pressure sensors and electrical micro-generators.
The authors of the study are Jackeline Narvaez, PhD student Fabián Vásquez-Sancho, and the ICREA Research Professor Gustau Catalan.
Widespread flexoelectricity
Flexoelectricity happens as a consequence of any asymmetry in the deformation of a material. Bending a material forces the atoms to get closer together in the inside of the bend, and spread apart on the outside. This redistribution of the atoms forces their electrical charges to also redistribute, which can be exploited to establish an electrical current between the inside and the outside of the bend.
Until now, it was known that all electrical insulators can be flexoelectric. The surprising discovery by the ICN2 scientists is that semiconductors can also be flexoelectric –and, in fact, they can generate more charge than insulators. The key ingredient of this new bending-induced electricity is in the surface of the materials.
The surface is the device
The Nature article describes how crystals of an initially insulating material are able to generate 1000 times more bending electricity when they are doped to become semiconductors. The reason is that, although the inside of these crystals does become conducting upon doping, the surfaces remain insulating. This means that the surfaces not only can still polarize, but in addition they receive a boost of extra charge from the semiconducting interior.
Because in semiconductors the electromechanical response is dominated by the surface rather than the bulk, the authors call this effect “flexoelectric-like”: the response is identical to flexoelectricity from a practical point of view (it is an electrical current generated in response to bending), but different from the fundamental point of view of its origin.
It is also noteworthy that measuring the flexoelectric response of the surface is an important scientific milestone in its own right. In all previous measurements, which were performed in insulators instead of semiconductors, the surface signal was always mixed with the bulk signal coming from the interior of the crystal. This is the first time that the response of the surface has been measured separately.
Flexoelectric semiconductors are also competitive at the macroscale
Traditional flexoelectricity (i.e. the flexoelectricity of insulators) is important at the nanoscale. Until now, however, it could not compete at the macroscale (the scale in which we humans live). Instead, the dominant effect at the macroscale was piezoelectricity, which is a property of some materials whereby they generate electricity in response to compression, rather than to bending. The reason is that materials are much harder to bend when they are thick (macroscale) than when they are thin (nanoscale); this is intuitive enough, just think how much harder it is to bend a 1000 page book compared to bending a single page of the same book.
However, the flexoelectric-like response of semiconductors has an important feature: it increases with the thickness of the material. Thus, the loss of flexibility is compensated by the increase of flexoelectricity, and this allows maintaining a competitive output independently of the device thickness. Crucially, this flexoelectric-like response can in principle be present in any (semiconducting) material, whereas piezoelectricity is only possible in a limited number of materials, the best of which are lead-based and therefore toxic.
The authors are so convinced of the potential usefulness of their discovery that they have filed a patent, and are currently seeking industrial partners to develop technological applications of semiconductor flexoelectricity.
Article: Jackeline Narvaez, Fabian Vasquez-Sancho, Gustau Catalan. Enhanced flexoelectric-like response in oxide semiconductors. Nature, 2016. Doi:10.1038/nature19761